Switching the input by displaying the input selection screen
The input of the image for projection can be selected by displaying the input selection screen.
1)
Press the <INPUT MENU> button on the remote control or control panel.
f The input selection screen is displayed.
Following input selection screen is an example when the optional Interface Board for HDMI 2 input (Model
No.: ET-MDNHM10) is installed in the slot.
2)
Press the <INPUT MENU> button again.
f The input will switch each time the <INPUT MENU> button is pressed.
Note
f Input can be switched by pressing as to select the input of the image for projection and pressing the <ENTER> button while the input
selection screen is displayed.
f If the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, the input
selection menu for the DIGITAL LINK output supported device is displayed when the <ENTER> button is pressed while the DIGITAL LINK
input is selected in the input selection screen.
f If the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, the DIGITAL
LINK logo and the input name selected in the DIGITAL LINK output supported device are displayed in the display section of the [DIGITAL
LINK] in the input selection screen.
76 - ENGLISH
Chapter 3 Basic Operations — Projecting
INPUT SELECT
HDMI
DVI-D
SDI
DIGITAL LINK
HDMI1 [SLOT]
HDMI2 [SLOT]
SELECT
SET
ENTER