Table of Contents
Advertisement
[LENS CALIBRATION]
Detect the lens shift adjustment limit value, and perform the calibration in the adjustment range. Execute the lens
calibration after attaching the projection lens.
1)
Press qw to select [LENS].
2)
Press the <ENTER> button.
f The [LENS] screen is displayed.
3)
Press as to select [LENS CALIBRATION].
4)
Press the <ENTER> button.
f The confirmation screen is displayed.
5)
Press qw to select [OK], and press the <ENTER> button.
f The lens calibration is started.
f After completing the calibration, the projection lens will move to the home position.
f To cancel, select [CANCEL].
Note
f [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f [INCOMPLETE] is displayed when the lens calibration is not performed correctly.
f The origin position of the lens mounter and the home position of the projection lens are automatically updated when the lens calibration is
performed.
The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the calibration result. It
does not match with the optical image center position.
f The home position varies depending on the projection lens type. Refer to "Lens shift range" (x page 80) for details.
f Pressing the <FOCUS> button on the remote control for at least three seconds will also display the confirmation screen for lens calibration
execution.
[OPERATION SETTING]
Set the operation method of the projector.
The settings are reflected when "Initial setting (operation setting)" (x page 68) in the [INITIAL SETTING]
screen is already set.
If you change the settings while using the projector, the duration until the brightness decreases to half may
shorten or the brightness may decrease.
Setting [OPERATING MODE]
1)
Press as to select [OPERATION SETTING].
2)
Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3)
Press as to select [OPERATING MODE].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
[QUIET]
*2
[QUIET1]
*3
[QUIET2]
*3
[USER1]
[USER2]
[USER3]
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
*2 Only for PT-RCQ80
*3 Only for PT-RCQ10
Chapter 4 Settings — [PROJECTOR SETUP] menu
Set this item to prioritize the brightness. The estimated runtime is approximately 20 000 hours
The brightness will decrease compared to [NORMAL], but set this item to increase the life of the light
source. The estimated runtime is approximately 24 000 hours
The brightness will decrease compared to [NORMAL], but select this item when operation with low
noise is prioritized. The estimated runtime is approximately 20 000 hours
The brightness will decrease compared to [QUIET1], but select this item when operating the projector
with less noise. The estimated runtime is approximately 20 000 hours
[MAX LIGHT OUTPUT LEVEL] and [LIGHT OUTPUT] can be set individually.
.
*1
.
*1
.
*1
dust.
3
ENGLISH - 143
.
*1
Advertisement
Table of Contents
