About The Rgb Input Indicator; About The Automatic Setup Function - Panasonic PT-LC75U Operating Instructions Manual

About the RGB INPUT indicator
The RGB INPUT indicator can be used to check whether an RGB/YPBPR
signal is being input. Refer to the table below for details.
RGB INPUT Power supply status
A signal is being input to
the connector selected
A signal is being input to
either the RGB1 IN or
No signal is being input to
the connector selected
using the input select
buttons.
No signal is being input to
either the RGB1 IN or
RGB2 IN connector.
About the automatic setup function
If you press the AUTO SETUP button, the items given in the table below will
be set automatically. The setting details change according to the signa!
which is being input. Refer to the table below for details.
Auto RGB
Dot clock input
clock phase | select/auto
YPBPR select
Horizontal/
vertical
position
Automatic
keystone
correction
VIDEO/
S-VIDEO
Clock is
100 MHz or
higher
NOTE:
e If the edges of the projected picture are indistinct, or if a dark picture is
being projected, the automatic setup processing may stop automatically
before it is complete. If this happens, project a different picture and then
press the AUTO SETUP button once more, or make the above
adjustments manually.
è If you would like to make further adjustments to the picture, use the menu
commands which are listed on page 26 and subsequent pages.
17