Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Making adjustments and selections
It is recommended to perform the focus adjustment after 30 minutes have elapsed with the focus test pattern
displayed.
For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 169).
1)
Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 77)
2)
Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 38)
f Refer to "Navigating through the menu" (x page 87) for the operation of the menu screen.
3)
Set [LENS TYPE].
f Confirm the setting of the lens type when using the projector for the first time after attaching the projection
lens. (x page 79)
4)
Press the input selection button (<HDMI>, <DVI-D>, <SDI>, <DIGITAL LINK>, <SLOT>) to select the
input.
5)
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 51)
6)
Press the <SHIFT> button to adjust the position of the projected image.
7)
If the input signal is DVI-D/HDMI signal, press the <AUTO SETUP> button.
8)
Press the <ZOOM> button to adjust the image size to match the screen.
9)
Press the <FOCUS> button again to adjust the focus.
10) Press the <ZOOM> button again to adjust the zoom to match the projected image size to the screen.
Note
f When the projector is switched on for the first time after purchase, or when the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY
RESET] is executed, the focus adjustment screen is displayed after projection starts, and then the [INITIAL SETTING] screen is displayed.
For details, refer to "When the initial setting screen is displayed" (x page 67).
2) 3)
4)
5)
1) 6) 8) 9) 10)
1) 9)
7)
ENGLISH - 73
6)
8) 10)
2) 3)
4)
Advertisement
Table of Contents
