Table of Contents
Advertisement
Using the data cloning function
Perform the operation of the data cloning function. Data such as the settings and adjustment values of the
projector can be copied to multiple projectors via LAN or using the USB memory.
r Data that cannot be copied
The following settings cannot be copied. Set these in each projector.
f The [PROJECTOR SETUP] menu → [PROJECTOR ID]
f The [PROJECTOR SETUP] menu → [DATE AND TIME] → [ADJUST CLOCK]
f The [PROJECTOR SETUP] menu → [DATA CLONING] → [LAN] → [WRITE PROTECT]
f The [SECURITY] menu → [SECURITY PASSWORD]
f The [NETWORK] menu → [WIRED LAN]
f The [NETWORK] menu → [WIRELESS LAN]
f The [NETWORK] menu → [PROJECTOR NAME]
f Security password
f Control device password
f Password set in "[Change password] page" (x page 206) of the web control screen
f Information of the CRT key and the self-signed certificate generated in "[Https set up] page" (x page 197) of
the web control screen, information of the installed server certificate
f "[E-mail set up] page" (x page 203) in the web control screen
f "[Authentication set up] page" (x page 204) in the web control screen
f "[Crestron Connected(TM)] page" (x page 208) in the web control screen
r Supported device
f Commercially available USB memory is supported.
The USB memory with a security function is not supported.
f Only the cards formatted in FAT16 or FAT32 can be used.
f Only the single partition structure is supported.
Note
f The data cloning function will not operate when the models of the projectors are different. For example, data of PT-RCQ10 can be copied to
other PT-RCQ10 projectors, but it cannot be copied to PT-RCQ80. Data cloning is limited to the same model.
Copying the data to another projector via LAN
Make the following settings on the projector of the copy destination in advance. For details, refer to "Setting
[WRITE PROTECT]" (x page 212).
f The [PROJECTOR SETUP] menu → [DATA CLONING] → [LAN] → [WRITE PROTECT] → [OFF]
1)
Connect all projectors to the hub using LAN cables. (x page 183)
2)
Turn on all the projectors.
3)
Press as to select [DATA CLONING] on the copy source projector.
4)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
5)
Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
6)
Press as to select [LAN].
7)
Press the <ENTER> button.
f The [LAN DATA CLONING] screen is displayed.
8)
Press as to select [SELECT PROJECTOR].
9)
Press the <ENTER> button.
f The projectors in the same subnet are displayed as a list.
10) Press as to select the copy destination projector.
Chapter 5 Operations — Using the data cloning function
ENGLISH - 211
Advertisement
Table of Contents
