Table of Contents
Advertisement
r For <SERIAL IN>/<SERIAL OUT> terminals
Connecting terminals of the synchronization source
Connecting terminals of the projector to synchronize
Communication cable (straight all connected)
Note
f The contrast synchronization function and the shutter synchronization function can be used simultaneously.
f For details on the settings of the contrast synchronization function and the shutter synchronization function, refer to the [PROJECTOR
SETUP] menu → [MULTI PROJECTOR SYNC] (x page 159).
f The menu items in the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] are common with the following setting items.
g The [PICTURE] menu → [DYNAMIC CONTRAST] → [USER] → [MULTI PROJECTOR SYNC]
g The [DISPLAY OPTION] menu → [SHUTTER SETTING] → [MULTI PROJECTOR SYNC]
f If there are any projectors which you do not want to synchronize within the linked projectors, set [CONTRAST SYNC] and [SHUTTER
SYNC] to [OFF] individually.
f The shutter synchronization function will operate even when there are different models within the linked projectors. However, the
synchronization function will not operate when there is a DLP projector that is constructed with three DLP chips within the linked projectors.
f To use the <SERIAL IN>/<SERIAL OUT> terminals, set the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] → [TERMINAL
SELECT] to [SERIAL].
62 - ENGLISH
Chapter 2 Getting Started — Connecting
Communication cable (straight all connected)
Communication cable (straight all connected)
Connecting terminals of the projector to synchronize
Connecting terminals of the projector to synchronize
Communication cable (straight all connected)
Advertisement
Table of Contents
