Table of Contents
Advertisement
24) Press as to select an item, and press qw to adjust the setting.
[NON-OVERLAPPED BLACK LEVEL]
Note
f [BRIGHTNESS ADJUST] is a function that makes the increased brightness in black level of the overlapping image area difficult to
notice when [EDGE BLENDING] is used to structure a multi-display screen. The optimal point of correction is set by adjusting [NON-
OVERLAPPED BLACK LEVEL] so the black level of the overlapping image area will be the same level as the non-overlapping area. If the
border area of the part where the image is overlapping and the non-overlapping part gets brighter after adjusting [NON-OVERLAPPED
BLACK LEVEL], adjust the width of the top, bottom, left, or right. Adjust [BLACK BORDER LEVEL] when the width adjustment makes only
the border area darker.
f The joining part may look discontinuous depending on the position you are looking from when a screen with high gain or rear screen is used.
f When structuring a multi-display screen using both horizontal and vertical edge blending, adjust [OVERLAPPED BLACK LEVEL] first before
making adjustments in Step 12). Adjustment method is same as the procedure of [NON-OVERLAPPED BLACK LEVEL].
f If only horizontal or vertical edge blending is used, set all items in [OVERLAPPED BLACK LEVEL] to 0.
f The [AUTO TESTPATTERN] setting will change in conjunction with the setting in the [DISPLAY OPTION] menu → [COLOR MATCHING] →
[AUTO TESTPATTERN].
f Adjustment of the tilt of the border between [NON-OVERLAPPED BLACK LEVEL] and [BLACK BORDER LEVEL] is a function to perform
edge blending together with the adjustment of [GEOMETRY] (x page 103). Perform the edge blending adjustment matching the shape in
[NON-OVERLAPPED BLACK LEVEL] following Steps 17) and 18) when [NON-OVERLAPPED BLACK LEVEL] is tilted due to correcting the
keystone with the [POSITION] menu → [GEOMETRY] → [KEYSTONE].
[FRAME RESPONSE]
Set image frame delay.
1)
Press as to select [FRAME RESPONSE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[FAST]
*1
[FIXED]
*2
*1 [FAST] cannot be set when input signal is not interlaced signal.
*2 Only when moving image signal or still image signal with the vertical scanning frequency of 50 Hz or 60 Hz is input
Note
f When [FAST] is set, the picture quality deteriorates. The [ADVANCED MENU] menu → [DIGITAL CINEMA REALITY] cannot be set.
[SMOOTH PIXEL DRIVE]
Enable/disable the SMOOTH PIXEL DRIVE function to enhance the resolution of the projected image.
1)
Press as to select [SMOOTH PIXEL DRIVE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
112 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
[BLACK BORDER WIDTH] (Right)
Projection range
[BLACK BORDER LEVEL]
Standard setting.
Simplifies the image processing to reduce image frame delay.
Sets image frame delay to be constant regardless of the image position or magnification.
Enables the SMOOTH PIXEL DRIVE.
Disables the SMOOTH PIXEL DRIVE.
Edge blending [WIDTH] (Right)
[MARKER] (Red)
Edge blending [START] (Right)
([MARKER] (Green))
[OVERLAPPED BLACK LEVEL] (Right)
Advertisement
Table of Contents
