Table of Contents
Advertisement
Executing the automatic setup
1)
Press as to select [AUTO SETUP].
2)
Press the <ENTER> button.
f The [AUTO SETUP] screen is displayed.
3)
Press as to select [EXECUTE], and press the <ENTER> button.
f The automatic setup is executed.
Note
f The automatic setup can also be executed by pressing the <AUTO SETUP> button on the remote control.
[BACKUP INPUT SETTING]
Set the backup function that switches the signal to the backup input signal as seamless as possible when input
signal is disrupted.
1)
Press as to select [BACKUP INPUT SETTING].
2)
Press the <ENTER> button.
f The [BACKUP INPUT SETTING] screen is displayed.
3)
Press as to select [BACKUP INPUT MODE].
4)
Press the <ENTER> button.
f The [BACKUP INPUT MODE] screen is displayed.
5)
Press as to select the combination of the input and press the <ENTER> button.
Primary input
[SDI]
[SDI]
[HDMI1 [SLOT]]
*1
[DVI-D1 [SLOT]]
*1
[SDI1 [SLOT]]
*1
*1 This is displayed when the optional Interface Board equipped with corresponding input is installed in the slot.
6)
Press the <MENU> button.
f The [BACKUP INPUT SETTING] screen is displayed.
7)
Press as to select [AUTOMATIC SWITCHING].
f [AUTOMATIC SWITCHING] cannot be selected when [BACKUP INPUT MODE] is set to [OFF].
8)
Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
[DISABLE]
Note
f The [BACKUP INPUT SETTING] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [NO SIGNAL SETTING] → [BACKUP INPUT SETTING]
f The backup function is enabled when [BACKUP INPUT MODE] is set to anything other than [OFF] and same signal is input to the primary
input and the secondary input.
f To switch to the backup input signal using the backup function, make sure that the following three conditions are satisfied to be ready to use
the function.
g Set [BACKUP INPUT MODE] to anything other than [OFF].
g Input the same signal to the primary and secondary inputs.
g Display the image of the primary input or secondary input.
f If the input is switched to other than the primary or secondary input while the backup function is ready for use, the state of readiness to
use the backup function is canceled. To switch to the backup input signal using the backup function again, switch to the primary input or
secondary input.
118 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Secondary input
[OFF]
[HDMI]
[DVI-D]
[HDMI2 [SLOT]]
*1
[DVI-D2 [SLOT]]
*1
[SDI3 [SLOT]]
*1
Switches to the secondary input (primary input) automatically when the input signal for primary input
(secondary input) is disrupted.
Disables the automatic input switching function.
Details
Disables the backup function.
Enables the backup function.
Advertisement
Table of Contents
