Table of Contents
Advertisement
Using the data cloning function
Perform the operation of the data cloning function. Data such as the settings and adjustment values of the
projector can be copied to multiple projectors via LAN.
r Data that cannot be copied
The following settings cannot be copied. Set these in each projector.
f The [PROJECTOR SETUP] menu → [PROJECTOR ID]
f The [PROJECTOR SETUP] menu → [DATE AND TIME] → [ADJUST CLOCK]
f The [PROJECTOR SETUP] menu → [DATA CLONING] → [WRITE PROTECT]
f The [SECURITY] menu → [SECURITY PASSWORD]
f The [SECURITY] menu → [CONTROL DEVICE SETUP]
f The [NETWORK] menu → [WIRED LAN]
f The [NETWORK] menu → [PROJECTOR NAME]
f The [NETWORK] menu → [NETWORK SECURITY]
f Security password
f Control device password
f Password set in "[Set up password] page (when accessed by administrator account)" (x page 217) of the web
control screen
f "[Network security] page" (x page 212) in the web control screen
f "[E-mail set up] page" (x page 213) in the web control screen
f "[Authentication set up] page" (x page 214) in the web control screen
f "[Crestron Connected(TM)] page" (x page 219) in the web control screen
f "[Crestron tools] page" (x page 216) in the web control screen
Note
f The data cloning function will not operate when the models of the projectors are different. For example, data of PT-RZ16K can be copied to
other PT-RZ16K projectors, but it cannot be copied to PT-RZ21K. Data cloning is limited to the same model.
Copying the data to another projector via LAN
Make the following settings on the projector of the copy destination in advance. For details, refer to "Setting
[WRITE PROTECT]" (x page 223).
f The [PROJECTOR SETUP] menu → [DATA CLONING] → [WRITE PROTECT] → [OFF]
Note
f To use the network function with the projector, it is necessary to set the password of the administrator account. (x page 192)
When a password is not set for the administrator account (when blank), the network function of the projector cannot be used. Set the
passwords for the copy source projector and the copy destination projector.
1)
Connect all projectors to a switching hub using LAN cables. (x page 199)
2)
Turn on all the projectors.
3)
Press as to select [DATA CLONING] on the copy source projector.
4)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
5)
Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
6)
Press as to select [SELECT PROJECTOR].
7)
Press the <ENTER> button.
f The projectors in the same subnet are displayed as a list.
8)
Press as to select the copy destination projector.
9)
Press the <ENTER> button.
f To select multiple projectors, repeat Steps 8) to 9).
222 - ENGLISH
Chapter 5 Operations — Using the data cloning function
Advertisement
Table of Contents
