A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up
Internet access, you are actually configuring one of the remote nodes.
4.1
Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1.
From the main menu, enter 11 to display Menu 11.
Step 2.
When Menu 11 appears, as shown next, enter the number of the remote node that you wish to
configure.
Remote Node Configuration
Remote Node Configuration
In this chapter, we discuss the parameters that are protocol independent.
The protocol-dependent configurations are covered in subsequent chapters.
Menu 11 - Remote Node Setup
1. ChangeMe (ISP,SUA)
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter Node # to Edit:
Figure 4-1 Menu 11 - Remote Node Setup
Prestige 643 ADSL Router
Chapter 4
4-1