Figure 27-3 Menu 24.5 System Maintenance - Backup Configuration; Figure 27-4 Menu 24.5 System Maintenance - Starting Xmodem Download Screen; Table 27-3 General Commands For Gui-Based Tftp Clients - ZyXEL Communications PRESTIGE 650H User Manual

Prestige 650 Series User's Guide
27.2.8 GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.

Table 27-3 General Commands for GUI-based TFTP Clients

COMMAND
Host Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's default IP address
when shipped.
Send/Fetch Use "Send" to upload the file to the Prestige and "Fetch" to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the Prestige. The filename for the firmware is "ras" and for the
configuration file, is "rom-0".
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Refer to section 27.2.5 to read about configurations that disallow TFTP and FTP over WAN.
27.2.9 Backup Via Console Port (only for the Prestige 650H/HW)
Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.5 and enter "y" at the following screen.

Figure 27-3 Menu 24.5 System Maintenance - Backup Configuration

Step 2. The following screen indicates that the Xmodem download has started.
Figure 27-4 Menu 24.5 System Maintenance – Starting Xmodem Download Screen
27-6
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...
DESCRIPTION
Firmware and Configuration File Maintenance