Insert The New Component; Insert The New Hard Disk - Nortel BCM50 Installation And Maintenance Manual

4 Gently lift the back of the Router card to disengage it from the card connector on the Compact
Services Card (CSC).
5 Slide the Router card back so the modular connectors clear the BCM50 bezel.
6 Lift the Router card over the top of the LED pipes and place it on a flat, clean, static-free
surface.
7
Continue to the next step,

Insert the new component

Use one of the following procedures to insert the new component:
• "Insert the new hard disk" on page 209
• "Insert the new fan" on page 211
• "Insert the new Router card" on page 212
Caution: Use only a Nortel Networks approved replacement part. Contact your
account representative for the current list of approved replacement parts.
Warning: Protect the hardware components against damage from electro-static
discharge. Always wear a ground wriststrap before you handle components.
Always place the components in static-free container.

Insert the new hard disk

To insert the BCM50 hard disk:
Caution: Do not use an electric or magnetized screwdriver near the hard disk.
You can lose the information stored on the disk. Shock can damage the hard disk.
Do not drop or hit the hard disk drive.
1
Attach one end of a grounding strap to your wrist and the other end to a grounded metal
surface.
2
Place the new hard disk on the hard disk bracket. Make sure the circuit board side of the hard
disk is facing the cross member of the hard disk bracket.
3
Use the four hard disk bracket screws to secure the hard disk to the bracket.
Caution: Use only the screws that you removed from the hard disk in the
procedure
the hard disk.
"Insert the new Router card" on page
"Remove the hard disk" on page

Insert the new component

212.
207. Using other screws may damage
Replace an internal component
209