Connect The Cables To The Patch Panel (Optional); Next Step - Nortel BCM50 Installation And Maintenance Manual

130

Next step

Connect the cables to the patch panel (optional)

If you are using the optional patch panel, use this procedure to connect the cables to WFC:
1
Plug the RJ21-end of the cable assembly into the telephony connector.
2 Plug the other end of the cable assembly into the patch panel header.
The cable locks in place.
3 Connect the wires (digital telephones, analog telephones, and analog trunks) to the patch
panel.
4 Connect cables to the BCM50 as required.

Next step

After you have connected the cables to the BCM50 system, you can configure the initial
parameters for the BCM50.
Refer to "Configure the basic BCM50 parameters" on page 147
these parameters.
Connect the cables to the BCM50 system
for information about configuring