Mount The Bcm50 Expansion Unit; Next Step - Nortel BCM50 Installation And Maintenance Manual

Mount the BCM50 Expansion Unit

The BCM50 Expansion Unit is installed close enough to the Main Unit so that the supplied
expansion cable can be connected between the BCM50 Expansion Unit and BCM50 Main Unit.
The BCM50 Expansion Unit can be mounted in a rack, on a wall, or on a desktop. Typically, the
BCM50 Expansion Unit is mounted in the same way that the Main Unit was mounted.
Use one of the following procedures to mount the BCM50 Expansion Unit:
• "Install the BCM50 unit in an equipment rack" on page 97
• "Install the BCM50 unit on the wall" on page 101
• "Install the BCM50 unit on a flat surface" on page 106

Next step

If you are installing a second BCM50 Expansion Unit on the system, repeat the procedures in this
section for the second BCM50 Expansion Unit.
After you have installed the BCM50 Expansion Unit, go to
system" on page 115.
Mount the BCM50 Expansion Unit
"Connect the cables to the BCM50
Install a BCM50 Expansion Unit
113