Install The Bcm50 Unit On A Flat Surface; Install The Bcm50 Unit On A Table Or Shelf; Figure 40 Location For Feet On The Bottom Of The Bcm50 Unit - Nortel BCM50 Installation And Maintenance Manual

106

Install the BCM50 unit on a flat surface

5 Optional – Install the three screws to secure the WFC in place.
6 Proceed to
Install the BCM50 unit on a flat surface
Use this procedure to install a BCM50 unit on any flat surface that can safely support the weight of
the units.
Caution: Refer to
environmental conditions before selecting a location for the BCM50 system.
Note: To keep the BCM50 operating at the optimal internal temperature, keep the top,
sides, and rear clear of obstructions and away from the exhaust of other equipment.
Do not place any objects, except other BCM50 units, on top of the Main Unit.

Install the BCM50 unit on a table or shelf

To install the BCM50 unit on a table or shelf:
1 Insert the power supply retention clip into the BCM50 unit.
2 Attach the four self-adhesive rubber feet to the bottom of the BCM50 unit by peeling off the
paper backing and placing the feet on the unit as indicated in

Figure 40 Location for feet on the bottom of the BCM50 unit

3
Position the BCM50 unit on a table or shelf. Make sure you leave enough space around the
unit for ventilation and access to the cables.
Install the BCM50 units
"Connect the cables to the wiring field card (optional)" on page
"Check the installation prerequisites" on page 83
129.
for acceptable
Figure 40.
Attach feet here