Device Change With Micro Sd Card On The 3Rw5 Hmi High Feature - Siemens SIRIUS 3RW55 Equipment Manual

Maintenance and service
10.6 "Device change" function
Operating principle
If the 3RW55 or 3RW55 Failsafe soft starter, the 3RW5 HMI High Feature or the
3RW5 communication module (accessory) has to be replaced because of a fault, you can transfer
data to your new device (identical type) using the "Device change" function or SIRIUS Soft Starter
ES (TIA Portal). To be able to transfer data, you must first save it.
The following data is transferred with the "Device change" function:
• I&M 1 data
• I&M 3 data
• Device parameters of the 3RW55 and 3RW55 Failsafe soft starters
• Device parameters of the 3RW5 HMI High Feature
• User administration / passwords
• Communication parameters
Note the information in chapter Firmware update (Page 22).
Transmission options
• Device change with micro SD card on the 3RW5 HMI High Feature (Page 282)
• Device change with SIRIUS Soft Starter ES (TIA Portal) (Page 283)
10.6.1

Device change with micro SD card on the 3RW5 HMI High Feature

Requirements
• Micro SD card with the saved data (Page 243)
– The folder (e.g. "1P3RW5 xxx-xxxxx+SLO...") is located in the root directory (top level).
– The article number in the name of the folder must match the article number of the 3RW55
– Menu: "Micro SD card > Save parameter settings to micro SD card"
282
or 3RW55 Failsafe soft starter. The serial number in the name of the folder ("SLO...") does
not need to match.
The data is saved in an automatically generated folder (e.g. "1P3RW5 xxx-xxxxx+SLO...").
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006