Sealing 3Rw55 And 3Rw55 Failsafe Soft Starters (Optional) - Siemens SIRIUS 3RW55 Equipment Manual

Commissioning

7.2 Sealing 3RW55 and 3RW55 Failsafe soft starters (optional)

7.2 Sealing 3RW55 and 3RW55 Failsafe soft starters (optional)
Requirements
• Seal, sealing wire and a suitable sealing tool
Procedure
Illustration similar
1. Push the wire through the openings provided.
2. Seal the wire to secure the hinged cover against unauthorized opening.
Result
By sealing the hinged cover, the interface cover of the 3RW5 HMI High Feature is protected
against unauthorized access. In addition, the 3RW5 HMI High Feature and the
3RW5 communication module (where present) are protected against unauthorized removal. It
is still possible to operate the 3RW5 HMI High Feature.
Tip
If you install the 3RW5 HMI High Feature outside of the 3RW55 or 3RW55 Failsafe soft starter, use
an anti-tamper seal on the interface cover to protect the local interface and the slot of the
micro SD card from unauthorized access. Proceed in the same sequence as for sealing the spring
flap.
You will find more information in chapter Design and operator controls of the High Feature 3RW5
HMI (Page 98).
126
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006