Siemens SIRIUS 3RW55 Equipment Manual page 67

• Continue to screw the screws into the fixing brackets
the front. Fasten the fixing brackets onto the 3RW5 HMI High Feature
• Tighten the 3RW5 HMI High Feature with a tightening torque of 0.3 ... 0.35 Nm
Ensure that all of the screw heads are in contact with the fixing bracket.
Procedure for installing the HMI connecting cable
• Use the opening to the cable duct
starter.
• It is possible to route the cable up or down in the cable duct.
Make sure that you install the cable in accordance with EMC requirements. For example,
install data cables separately from the motor cable. Connect both sides of shielded cables
over a large surface area.
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006
4.4 Installing, mounting and removing the 3RW5 HMI High Feature
①
to install the cable in the 3RW55 or 3RW55 Failsafe soft
Mounting and dismantling
③
until they protrude approx. 8 mm at
④
.
⑤
.
67