Siemens SIRIUS 3RW55 Equipment Manual page 115

- Local interface activated 1)
- Local interface deactivated
- Timer lighting dark
- Do control after log off
∟ Continue with motor control
∟ Stop motor and give back control
- Messages to show
∟ Errors
∟ Enable
∟ Disable
∟ Warnings
∟ Enable
∟ Disable
- Operation display
∟ Measured value 1
∟ Phase current average (%)
∟ Measured value 2
∟ Phase current average (rms)
∟ Measured value 3
∟ Line voltage U L1-L2 (rms)
∟ Measured value 4
2)
∟ Active power
∟ Measured value 5
∟ Power factor L1...3 2)
- Edit function favorites
∟ F1 3)
∟ F2 3)
∟ F3 4)
∟ F4 4)
∟ F5 4)
∟ F6 4)
∟ F7 4)
∟ F8 4)
∟ F9 4)
- Configure start key
∟ Control command 1
∟ Motor CW 5)
∟ Control command 2
5)
∟ No start type selected
∟ Control command 3
∟ No start type selected 5)
∟ Control command 4
∟ No start type selected 5)
- Languages 6)
1) Display depends on the current setting
Further menu items. Refer to chapter Monitoring the measured values of the 3RW55 soft starter with the 3RW5 HMI High
2)
Feature (Page 227).
3) Menu items are permanently set. Refer to chapter Configuring the Function selection key F1-F9 of the 3RW5 HMI High
Feature (Page 117).
Contains the lower level with menu items. Refer to chapter Configuring the Function selection key F1-F9 of the 3RW5 HMI
4)
High Feature (Page 117).
Further menu items. Refer to chapter Configuring the start key of the 3RW5 HMI High Feature (Page 119).
5)
Contains the lower level with settable languages.
6)
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006
Parameters [11/12]
HMI
1)
2)
2)
2)
Parameter assignment
6.7 Menu of the 3RW5 HMI High Feature
Setting
Factory
x
5 min
x
x
x
x
x
x
x
x
Local / Remote
x
x
x
x
English
Setting
Customer
Reset
115