Analog Output Configuration; Identifying The Output Type; Channel Menu Items; Output Selection - Honeywell SC1000 Owner's Manual

11.7 Analog Output Configuration

11.7.1 Identifying the
Output Type
11.7.2 Channel Menu
Items

11.7.3 Output Selection

page 94 008-0608-00
An AC/AC-LVDT Input channel is available with one of two types of digital-to-analog
(DAC) outputs: voltage or current. You can determine which type of output a channel
has by one of three ways:
• Consulting the instrument's Customer Information Sheet
• Examining the
SYSTEM MENU
the number of the channel. If the channel's type is
output. If the channel's type is
• Examining the channel's circuit board as shown in the figure below.
The Analog Output can be driven by any channel's track, peak or valley value.
See the "Channel Menu" section earlier in this chapter for a complete listing of SETUP
menu items available on the
Jumpers located on the channel's circuit board determine what outputs are generated
when the value selected to drive the Analog Output (from the
menu items) equals the
SOURCE
Figure 11-2: Digital-to-Analog Output Jumper Locations
DAC. ZERO SCALE
Output
CHANNELS WITH VOLTAGE OUPUT
0-5V 2.5 Volts
±5V 0 Volts
0-10V 5 Volts
±10V 0 Volts
CHANNELS WITH CURRENT OUTPUT
4-20mA 4 mA
4-20mA 12 mA
-> ->
CONFIGURATION CHANNEL
AC-AC LVDT V
, it has a current output.
AC-AC LVDT I
sub-menu.
DAC. SETUP
and
DAC. FULL SCALE DAC. ZERO SCALE
DAC. FULL SCALE
Output
5 Volts
5 Volts
10 Volts
10 Volts
20 mA
20 mA
nn menu item where nn is
TYPE
, it has a voltage
and
DAC. CHANNEL
settings.
J30 J31
jumper jumper
open closed
open open
closed closed
closed open
open open
open closed
DAC.