Display Menu; Overview; Menu Items For Models Sc1000, Sc2000, Sc2001; Upper Channel Menu Item - Honeywell SC1000 Owner's Manual

8.1 Overview

8.2 Menu Items for Models SC1000, SC2000, SC2001

8.2.1 Menu
UPPER CHANNEL
Item
8.2.2 Menu
LOWER CHANNEL
Item
8.2.3 Menu
LOWER MODE
Item
8.2.4
DISPLAY DISABLE
Menu Item

8.3 Menu Items for Model SC3004

8.3.1
POWER-ON CHANNEL
Menu Item
The Display menu allows you to examine and change settings that affect the oper-
ation of the display of the SC instrument. You can change which channel is dis-
played when the instrument is powered-up and what information is shown on the
lower line of SC1000, SC2000 and SC2001 instruments.
Detailed instructions on operating the SC instrument in the SETUP Menu mode
can be found in "SETUP Menu mode" on page 23. A diagram of all menus is
located in the "Setup Menu Reference" on page 157.
These instruments have a dual-line display which consists of an upper line and a
lower line.
Specifies the channel that is displayed on the upper line when the instrument is
powered-up.
To change whether the channel's track, peak or valley data value is displayed on
power-up, use the channel's "
Specifies the channel that is displayed on the lower line when the "
menu item is set to "
CHANNEL
To change whether the channel's track, peak or valley data value is displayed on
power-up, use the channel's "
Determines what is displayed on the lower line. The choices are:
• " " means that nothing is displayed.
BLANK
• " " means that the status of Limit 1, Limit 2, Limit 3, and Limit 4 are
LIMIT 01-04
displayed as described in "Indicator Lights" on page 21
• " " means that the channel specified with the "
CHANNEL
is displayed.
Determines if the display is enabled or not. In some applications, the display is
not used in order to reduce power consumption; the instrument is then completely
controlled with the Serial Communications interface. The choices are:
• " " means that the display operates normally.
OFF
• " " means that the display is blanked after the instrument is powered up.
ON
Pressing any button on the front panel will temporarily re-enable the display
until the instrument is reset.
Specifies the channel that is selected when the instrument is powered up.
To change whether the channel's track, peak or valley data value is displayed on
power-up, use the channel's "
->
OPERATION POWER-ON SOURCE
".
->
OPERATION POWER-ON SOURCE
->
OPERATION POWER-ON SOURCE
SC Series Instruction Manual
Chapter 8

Display Menu

" menu item.
"
LOWER MODE
" menu item.
" menu item
LOWER CHANNEL
" menu item.
page 51