Display Setup Sub-Menu; Auxn Function Menu Items - Honeywell SC1000 Owner's Manual

11.5.2
DISPLAY SETUP
Sub-Menu
Menu Item
DISPLAY. DIGITS
Menu Item
DISPLAY. DECPT
Menu Item
DISPLAY. COUNT-BY
Menu Item
DISPLAY. UNITS
Menu Item
DISPLAY. AVERAGE
11.5.3 Menu
AUXn FUNCTION
Items
This menu controls how data values are displayed by the channel and transmitted
via serial communications.
Selects the number of digits displayed by the channel. The choices are:
• " " displays both positive and negative numbers with five full dig-
5 DIGIT-BIPOLAR
its (±99999).
• " " displays positive numbers with six full digits (999999) and
6 DIGIT-UNIPLOAR
negative numbers with five full digits (-99999).
• " displays positive number with seven full digits (9999999)
7 DIGIT UNIPOLAR"
and negative numbers with six digits (-999999).
Selects the decimal point location on the channel's display and serial communica-
tions output. Use the [UP] and [DOWN] buttons to move the decimal point to the
right and left.
Determines by what value the display increments or decrements. This will make
the display less sensitive to a noisy signal. The choices are:
• " "
00001
• " "
00002
• " "
00005
• " "
00010
• " "
00020
• " "
00050
• " "
00100
• " "
00200
Specifies the four character label that is displayed to the right of the channel's val-
ues.
NOTICE
This menu item doesn't change the mathematical scaling of the channel's val-
ues; that can be changed by altering the "
menu items and then performing a re-calibration.
When a character position is flashing press the [UP] or [DOWN] button to change
the character. Press [ENTER] to advance to the next character.
Controls the speed with which the channel's display values will update. Display
averaging does not affect the channel's analog output or its peak/valley detection,
which will proceed at the speed selected by the "
item. The choices are:
• " " means that the display will update four times each second. The channel's
ON
values will be averaged for 1/4 second, then displayed.
• " " means that the channel's display will update as quickly as possible.
OFF
The and
AUX1 FUNCTION AUX2 FUNCTION
Auxiliary Function pins (labeled as "AUX1" and "AUX2") on the channel's connec-
tor are activated. These pins are "activated" when they are connected to the
DGND pin. The choices are:
• " " means that activating the pin does nothing.
DISABLED
• " " means that the tracking, peak and valley values will not be
TRACK HOLD
->
CALIBRATION DATA
->
OPERATION
menu items determine what happens when the
SC Series Instruction Manual
"
KNOWN POINT X/Y
" menu
FREQ. RESPONSE
page 85