Function Input Pins; Overview; Example - Honeywell SC1000 Owner's Manual

5.3 Function Input Pins

5.3.1 Overview

5.3.2 Example

To use a Function Input pin (9, 10, 11 or 21), connect it to the DGND (pin 19) momen-
tarily. This can be accomplished by a push button switch, relay contact closure, or
PLC output.
Usually, the Function Input pins perform the default actions described in the "System
Connector Pinout" on page 36. However, a SensoCode program running on a Mathe-
matics Virtual Channel may replace these default actions. Consult the Customer
Information Sheet included with your instrument for details.
For example, assume that you wish to use Function Input #3 to tare all channels in the
instrument simultaneously. Connect a push-button switch as shown below.
Figure 5-1: Function Input Example
SC Series Instruction Manual page 37