Honeywell SC1000 Owner's Manual page 72

page 72 008-0608-00
applied this load to the transducer, press [ENTER].
• Upon completion, the display will indicate
RUN mode.
If the is 5-Point Known Load Calibration...
CALIBRATION TYPE
• The display will read
DOING 5POINT CAL
00000 and UNIT are previously entered as
When you have applied this load to the transducer, press [ENTER].
• The display will read
WORKING
viously entered as
KNOWN POINT 2/5
load to the transducer, press [ENTER].
• The display will read
WORKING
viously entered as
KNOWN POINT 3/5
load to the transducer, press [ENTER].
• The display will read
WORKING
viously entered as
KNOWN POINT 4/5
load to the transducer, press [ENTER].
• The display will read
WORKING
viously entered as
KNOWN POINT 5/5
load to the transducer, press [ENTER].
• The display will now read
indicate and the instrument will return to the RUN mode. If you use the [UP]
DONE
button and [ENTER] to select
loads again but in reverse order. This will allow the instrument to measure and
partially eliminate any hysteresis that may be present in the transducer. After the
loads have been applied again, the display will indicate
will return to the RUN mode.
and the instrument will return to the
DONE
, and prompt you to
KNOWN POINT 1/5
, then (where 00250 and UNIT are pre-
APPLY 00250 UNIT
and ). When you have applied this
DISPLAY. UNITS
, then (where 00500 and UNIT are pre-
APPLY 00500 UNIT
and ). When you have applied this
DISPLAY. UNITS
, then (where 00750 and UNIT are pre-
APPLY 00750 UNIT
and ). When you have applied this
DISPLAY. UNITS
, then (where 01000 and UNIT are pre-
APPLY 01000 UNIT
and ). When you have applied this
DISPLAY. UNITS
. If you press [ENTER], the display will
RETURN PNTS.=NO
, you may now apply the same
RETURN POINTS=YES
(where
APPLY 00000 UNIT
and ).
DISPLAY. UNITS
and the instrument
DONE