Power On/Off Procedures; Powering Up The Ek15 - Simrad EK15 Reference Manual

Simrad EK15

Power on/off procedures

These procedures explain how to switch the EK15 system on and off.
Note
When you power up the EK15 for the very first time, observe the procedures in chapter
Installation on page 287.
Topics
• Powering up the EK15 on page 44
• Powering down the EK15 on page 45

Powering up the EK15

Purpose
This procedure explains how to power up the Simrad EK15 system.
This procedure assumes that you have connected one or more transceiver to the EK15. If
this is not the case, observe the relevant start-up procedure in chapter Installation.
Related topics
• Setting operational mode 'Normal' to start 'pinging' on page 24
• Starting normal operation on page 23
• Checking the bottom detector settings on page 26
• Setting up the EK15 transceiver(s) for the first time on page 289
• Operation menu on page 136
• User Settings dialog box on page 142
• Ping function on page 151
Procedure
1 Verify that the transceiver(s) are switched on.
The Single Beam Transceiver (SBT) is not provided with an on/off switch.
Unless a dedicated solution has been provided during the installation to facilitate
power on/off, the transceiver(s) are permanently powered up. However, if the EK15
has not been used for a longer period of time, the power to the transceiver(s) may
have been disconnected.
Power up the colour display.
2
If required, refer to the instructions provided by the display manufacturer.
3 Power up the Processor Unit (computer).
Wait for the operating system to start up.
4 Double-click the EK15 icon on the desktop to start the program.
5 Wait while the program starts on the computer.
44
351718/C