Table of Contents
Advertisement
Description
To support programs which
use data from the Simrad
EK500 echo sounder, the
EK15 can output a subset
of the EK500 defined
datagrams. This dialog box
allows you to enable or
disable the EK500 datagram
output to the Ethernet port.
This output port is not
managed by the
I/O Setup
dialog box, but handled
separately from this dialog
box.
Parameters
1
Output EK500
Click this box to enable or disable the EK500 datagram output.
Note
In order to disable EK500 datagram output, you must also open the
dialog and clear all data format check boxes.
2
EK500 Datagram
Click the button to open the
can set up the individual datagrams to be exported.
3
Local IP Address
This is the Internet Protocol (IP) address of the local Ethernet interface board.
In most cases, each Ethernet board has a unique IP address, even when an interface
board supports multiple sockets. If you have more than one interface board, you are
provided with a list of the available addresses.
4
Remote port (UDP)
Specify the local network port. The EK15 uses this network port to transmit
information. The application on the remote computer will "listen" to this port
number.
5
Remote IP Address
Select the Internet Protocol (IP) address for the remote computer.
If the data communication is set up to receive data only, this parameter is
not required. If you wish to set up an output for broadcast, define IP address
255.255.255.255
If you use point-to-point communication in a closed network, you need to enter
the remote IP address manually.
351718/C
EK500 Datagram
. This is the default setting.
Functions and dialog boxes
dialog box. In this dialog box, you
EK500 Datagram
185
Advertisement
Table of Contents
