Table of Contents
Advertisement
3
Identity
This information reflects the type of transceiver connected, and the transceiver's
unique Ethernet address.
means Single Beam Transceiver.
SBT
4
Version
This information includes the unique version parameters provided by the transceiver.
Codes identifying frequency, serial number and firmware are provided.
5
SW Version
This is the software version currently running on the transceiver.
6
IP Address
This is the transceiver's current IP address.
Note
If you use more than one transceiver, these must be set up using different IP
addresses.
7
Connected IP Address
This is the IP address of the computer's Ethernet board that is used to communicate
with the transceiver(s).
8
Available
This parameter identifies if the selected frequency channel is currently available for
use with the EK15. If it is available, the status is identified as True.
Topics
• Transceiver Installation dialog box; Channel list on page 201
• Transceiver Installation; Transceiver information on page 202
• Transceiver Installation; Transceiver browsing on page 203
Related procedures
• Installing a frequency channel on page 81
• Disconnecting a frequency channel on page 82
• Modifying a transceiver IP address on page 82
Related topics
• Setup menu; functions and dialogs on page 170
• Normal Operation dialog box on page 154
• Installation menu on page 189
Transceiver Installation; Transceiver browsing
Purpose
The
parameters are used when you wish to start an automatic search for
Browser
transceivers on the network. The communication is made between your computer
(identified with its
Local IP Address
351718/C
) and one or more transceivers.
Functions and dialog boxes
203
Advertisement
Table of Contents
