Simrad EK15 Reference Manual page 85

Description
The transceivers are provided by Simrad readily set up with a fixed Ethernet address and
an IP address. If your EK15 uses two or more transceivers, these will by default have
different Ethernet addresses, but identical IP addresses. In order for your system to work,
all transceivers must have unique IP addresses.
If you have bought complete EK15 system that includes a computer and the required
number of transceivers, this configuration was done at the factory. However, if you have
purchased your own computer, and adds additional transceivers to an existing system,
you must do this yourself, or leave it to your dealer.
Related topics
• Setup menu on page 138
• Transceiver Installation dialog box on page 199
Procedure
Click the icon.
1
Setup
This icon is located under the
Click the
2
Installation
On the menu, click
dialog box.
The purpose of the
parameters to connect the EK15 computer to the transceiver(s) and the transducer(s).
3 Observe that the current frequency channels are listed in the dialog box.
4 Click once on the frequency channel you wish to modify.
5 Observe that the relevant transceiver parameters are shown in the
field
Information
6 Set the transducer(s) to None, and click
7 Click
Change IP Address
Note
If you have two Ethernet cables connected to your computer, you may need to
disconnect the Ethernet cable to the ship's network before the
is available.
351718/C
menu. It is used to open the
Main
button to open the
Installation
Transceiver Installation
Transceiver Installation
Apply
to open the
IP Address
Operational procedures
menu.
to open the
Transceiver Installation
dialog box is to set up the necessary
.
dialog box.
Change IP Address
menu.
Setup
Transceiver
83