Table of Contents
Advertisement
Simrad EK15
Parameters
1
Available Outputs
This field lists the available output signals.
The available sources are defined in a configuration file on the EK15, and reflects
the export data and file formats the EK15 can support.
a
Depth
This is the depth output. The following telegram formats are supported:
→ DBS Depth below surface on page 250
→ DBT Depth below transducer on page 251
→ DPT Depth on page 251
→ Simrad EK500 Depth telegram on page 257
→ Atlas depth telegram on page 266
→ PSIMDHB Bottom hardness and biomass on page 263
Tip
You can also set up depth outputs using the
menu.
→ Depth Output dialog box on page 186
b
Sync
This is the output for synchronization of peripheral acoustic systems.
For more information, see the
→ Synchronization dialog box on page 171
2
Selected Outputs
This field lists the selected output signals to the relevant communication port.
3
Configure Output
Some of the outputs may be set up by the EK15. To do this, click on the output
name in the
Selected Outputs
relevant setup dialog will open.
Related topics
• External interface procedures on page 87
• I/O Setup dialog box on page 194
• Depth Output dialog box on page 186
• Synchronization dialog box on page 171
• Setting up export of NMEA data to chosen LAN port on page 88
232
Depth Output
Synchronization
field, and then this button. When applicable, the
dialog on the
dialog box.
Setup
351718/C
Advertisement
Table of Contents
