The upper part of the
channels which either are, or have been, installed on the EK15. For each channel on the
list, a
label is provided.
Status
The following status values are available in the
•
: The frequency channel is already in use, probably by another echo sounder on
Busy
the same network. You can not connect to this channel.
•
: This frequency channel is connected to your EK15 system.
Installed
•
: This frequency channel can not be used.
Lost
•
: This frequency channel is vacant and ready for use.
Available
Related topics
• Setup menu on page 138
• Checking the transceiver and transducer settings on page 25
• Transceiver Installation dialog box on page 199
Procedure
1
Click the
Setup
This icon is located under the
2
Click the
Installation
On the menu, click
dialog box.
The purpose of the
parameters to connect the EK15 computer to the transceiver(s) and the transducer(s).
In the
3
Transceiver Installation
The EK15 will automatically search the network for transceivers.
Observe that all the frequency channels are listed in the dialog box.
4
Select a frequency channel that is available, and choose the correct transducer in
5
the spin box.
Note
This is a critical task. You must ensure that the correct transducer is selected. If
you connect the transceiver to a transducer that can not handle the power rating, it
may be damaged beyond repair.
On the EK15, choose transducer
be used.
6
Observe that the status for the relevant frequency channels changes to Installed.
7
Click
to save the current settings and close the dialog box.
OK
351718/C
Transceiver Installation
icon.
menu. It is used to open the
Main
button to open the
Transceiver Installation
Transceiver Installation
dialog box, click
200–28CM
dialog box displays a list of frequency
Transceiver Installation
menu.
Installation
to open the
Transceiver Installation
dialog box is to set up the necessary
.
Browse
as default. Other transducers can also
Installation
dialog box.
menu.
Setup
291