Simrad EK15 Reference Manual page 206

Simrad EK15
To search your network for transceivers, check that the IP address of your computer's
Ethernet board is shown, and click the
the computer through the network are automatically listed in the channel list. Each
transceiver is identified with its applicable status label.
Parameters
1
Local IP Address
This is the Internet Protocol (IP) address of the local Ethernet interface board. If
you have more than one interface board, you are provided with a list of the available
addresses.
Important
The Ethernet board used to communicate with the EK15 transceiver(s) must be set
up in the same address range as the transceiver(s).
Use the following Internet Protocol (IP) addresses on the computer's Ethernet board:
IP Address:
157.237.14.60
Subnet mask:
255.255.255.0
If you have more than one Ethernet board in your computer, set up one to
communicate with the transceiver(s) using the IP address and Subnet mask shown,
and one to communicate with another local area network. You must use the
operating system's functionality to set up these IP addresses.
2
Remote IP Address
Select the Internet Protocol (IP) address for the remote transceiver.
If you wish to locate a transceiver using Point-to-Point communication, enter the
Internet Protocol (IP) address for the transceiver.
If you don't know the transceiver's IP address, leave this field blank, and use
Broadcast communication.
3
Communication mode
Choose Broadcast or Point-to-Point.
Use Broadcast if you do not know the Internet Protocol (IP) address of the
transceiver.
Use Point-to-Point if you know the Internet Protocol (IP) address of the transceiver.
You must then enter the transceiver's IP address into the
4
Browse
This button initiates a search on the network for available transceivers. The
transceivers that are found are automatically listed in the channel list with their
appropriate statuses.
Topics
• Transceiver Installation dialog box; Channel list on page 201
• Transceiver Installation; Transceiver information on page 202
• Transceiver Installation; Transceiver browsing on page 203
204
button. All transceivers connected to
Browse
field.
Remote IP Address
351718/C