Advertisement
Stowing the emergency spare wheel
Place the collapsible emergency spare wheel
X
into the emergency spare wheel bag and
close the emergency spare wheel bag.
Place the emergency spare wheel bag with
X
the collapsible emergency spare wheel into
the luggage compartment with the carrying
strap at the back.
Hook retaining spring hooks : of fastening
X
strap ; into the lashing eyelets.
Tighten fastening strap ;.
X
Inflating the collapsible emergency
spare wheel (Mercedes-AMG GLE 63)
!
Inflate the collapsible emergency spare
wheel using the tyre inflation compressor
before lowering the vehicle. The wheel rim
could otherwise be damaged.
!
Do not operate the tyre inflation compres-
sor for longer than eight minutes at a time
without a break. It may otherwise overheat.
The tyre inflation compressor can be oper-
ated again once it has cooled down.
Comply with the manufacturer's safety instruc-
tions on the tyre inflation compressor label and
on the tyre sealant bottle.
Mount the collapsible emergency spare wheel
X
as described (
page 414).
Y
The collapsible emergency spare wheel must
be mounted before it is inflated.
Remove the tyre inflation compressor from
X
the stowage space under the luggage com-
partment floor (
page 387).
Y
Emergency spare wheel
Pull connector ? and hose B out of the
X
housing.
Remove the cap from the valve on the col-
X
lapsible emergency spare wheel.
Screw union nut ; of hose B onto the valve.
X
Make sure on/off switch A of the tyre infla-
X
tion compressor is set to 0.
Insert connector ? into a socket in your vehi-
X
cle.
Cigarette lighter socket: (
12 V sockets: (
page 364)
Y
Observe the notes on the cigarette lighter
(
page 364). Observe the notes on sockets
Y
(
page 364).
Y
Turn the key to position 1 in the ignition lock
X
(
page 158).
Y
Press on and off switch A on the tyre inflation
X
compressor to I.
The tyre inflation compressor is switched on.
The tyre is inflated. The tyre pressure is shown
on pressure gauge =.
Pump the tyre to the specified tyre pressure.
X
The specified tyre pressure is printed on the
yellow label of the emergency spare wheel.
When the specified tyre pressure has been
X
reached, press on and off switch A on the
electric air pump to 0.
The tyre inflation compressor is switched off.
Turn the key to position 0 in the ignition lock.
X
If the tyre pressure is higher than the speci-
X
fied pressure, press pressure release valve
button : until the correct tyre pressure has
been reached.
Unscrew union nut ; on hose B from the
X
valve.
Screw the valve cap onto the collapsible
X
emergency spare wheel valve again.
Stow connector ? and hose B in the lower
X
section of the tyre inflation compressor.
Stow the tyre inflation compressor in the vehi-
X
cle.
431
page 364)
Y
Z
Advertisement
