Advertisement
Operating the climate control system
146
ing sunroof): press and hold the d button
until the side windows are closed.
The indicator lamp in the d button lights
up. Air-recirculation mode is activated.
If parts of the body are in the closing area during
convenience closing, proceed as follows:
Press the W button to stop the side win-
X
dows.
The side windows stop.
To then open the side windows, press the
X
W button again.
or
Press and hold the d button again for at
X
least two seconds.
The side windows move in the opposite direc-
tion.
Only vehicles with sliding sunroof or pan-
X
orama sliding sunroof: press the 2
switch to stop the sliding sunroof or pano-
rama sliding sunroof.
The sliding sunroof or panorama sliding sun-
roof stops.
To then open the sliding sunroof or panorama
X
sliding sunroof, pull back on the 2 switch.
i
If the sliding sunroof is raised and closes,
press the 2 switch, to stop the sliding
sunroof. Do not pull back on the 2 switch
afterwards. The sliding sunroof closes before
it opens.
i
Notes on the automatic reversing feature
for:
the side windows (
R
the panorama sliding sunroof
R
(
page 102)
Y
the sliding sunroof (
R
Convenience opening feature (vehicles
X
with sliding sunroof or panorama sliding
sunroof): press and hold the d button
until the side windows and the panorama slid-
ing sunroof are open. The side windows and
the sliding sunroof or panorama sliding sun-
roof move back to their original position.
The indicator lamp in the d button goes
out. Air-recirculation mode is deactivated.
Convenience opening feature (vehicles
X
without sliding sunroof or panorama slid-
ing sunroof): press and hold the d button
until the side windows are open. The side win-
dows move back to their original positions.
The indicator lamp in the d button goes
out. Air-recirculation mode is deactivated.
page 98)
Y
page 102)
Y
i
If you open the side windows or the sliding
sunroof or the panorama sliding sunroof man-
ually after closing them with the convenience
closing feature, they will remain in this posi-
tion when opened using the convenience
opening feature.
Switching the residual heat on/off
General notes
It is possible to make use of the residual heat of
the engine to continue heating the stationary
vehicle for up to 30 minutesafter the engine has
been switched off. The heating time depends on
the set interior temperature.
Switching on/off
To switch on: press the Ì or Á button.
X
The indicator lamp in the Ì or Á button
lights up.
i
The blower will run at a low speed regardless
of the airflow setting.
i
If you activate the residual heat function at
high temperatures, only the ventilation will be
activated. The blower runs at medium speed.
To switch off: press the Ì or Á but-
X
ton.
The indicator lamp in the Ì or Á button
goes out.
Residual heat is deactivated automatically:
after approximately 30 minutes
R
when the ignition is switched on
R
if the battery voltage drops
R
when the auxiliary heating is switched on
R
Ionisation
Ionisation is used to purify and freshen the air in
the vehicle interior, which is conducive to a
pleasant climate.
The ionisation of the interior air is odourless and
cannot, directly, be perceived in the vehicle inte-
rior.
You can switch ionisation on and off via the mul-
timedia system (see the separate operating
instructions).
Advertisement
