Advertisement
Display messages
328
Display messages
DISTRONIC PLUS
DISTRONIC PLUS
- - - km/h
- - - km/h
DISTRONIC PLUS and
DISTRONIC PLUS and
SPEEDTRONIC inoper‐
SPEEDTRONIC inoper‐
ative
ative
DTR+: steering
DTR+: steering
assist. currently
assist. currently
unavailable See
unavailable
er's Manual
er's Manual
DTR+: steering
DTR+: steering
assistant inopera‐
assistant inopera‐
tive
tive
Cruise control and
Cruise control and
SPEEDTRONIC inoper‐
SPEEDTRONIC inoper‐
ative
ative
SPEEDTRONIC suspen‐
SPEEDTRONIC suspen‐
ded
ded
SPEEDTRONIC Limit
SPEEDTRONIC Limit
--- km/h
--- km/h
Possible causes/consequences and M M Solutions
An activation condition for DISTRONIC PLUS is not fulfilled.
Check the activation conditions for DISTRONIC PLUS (
X
DISTRONIC PLUS and SPEEDTRONIC are faulty.
Steering Assist and Stop&Go Pilot are therefore also unavailable.
A warning tone also sounds.
Consult a qualified specialist workshop.
X
Steering Assist and Stop&Go Pilot are temporarily inoperative.
Possible causes:
See Own‐
Own‐
the windscreen is dirty in the camera's field of vision
R
visibility is impaired due to heavy rain, snow or fog
R
there have been no lane markings for an extended period
R
the lane markings are worn, dark or covered, e.g. by dirt or snow
R
Once the causes listed above no longer apply, the display message
goes out.
Steering Assist and Stop&Go Pilot are operative again.
If the display message does not disappear:
Pull over and stop the vehicle safely as soon as possible, paying
X
attention to road and traffic conditions.
Safeguard the vehicle against rolling away (
X
Clean the windscreen.
X
Steering Assist and Stop&Go Pilot are faulty.
However, the DISTRONIC PLUS functions are still available.
A warning tone also sounds.
Consult a qualified specialist workshop.
X
SPEEDTRONIC and cruise control are malfunctioning.
Consult a qualified specialist workshop.
X
If you depress the accelerator pedal beyond the pressure point (kick-
down), SPEEDTRONIC is switched to passive mode.
The speed limitation is not active.
Drive slower than the stored speed and without kickdown.
X
Call up the last speed stored again.
X
or
Set a new speed.
X
When the display message disappears, the speed limitation is active.
SPEEDTRONIC cannot be activated, as the activation conditions have
not all been met.
Check the activation conditions for SPEEDTRONIC (
X
page 207).
Y
page 191).
Y
page 205).
Y
Advertisement
