Advertisement
To direct the airflow through the footwell vents
A
To switch the seat heating on the left-hand side on/off
B
Information on using THERMATIC
automatic climate control
The following contains notes and recommenda-
tions on optimum use of THERMATIC automatic
climate control.
Activate climate control using the à and
R
Á buttons. The indicator lamps in the
à and Á buttons light up.
Set the temperature to 22 †.
R
Only use the "Windscreen demisting" function
R
briefly until the windscreen is clear again.
Only use air-recirculation mode briefly, e.g. if
R
there are unpleasant outside odours or when
in a tunnel. The windows could otherwise mist
up as no fresh air is drawn into the vehicle in
air-recirculation mode.
Use the ZONE function to adopt the temper-
R
ature settings on the driver's side for the
front-passenger side as well. The indicator
lamp above the á button goes out.
If you change the settings of the climate con-
R
trol system, the climate status display
appears for approximately three seconds at
the bottom of the screen in the multimedia
system display. You will see the current set-
tings of the various climate control functions.
During automatic engine switch-off, the climate
control only operates at a reduced capacity. If
you require the full climate control output, you
can switch off the ECO start/stop function by
pressing the ECO button (
Overview of climate control systems
page 163).
Y
137
Advertisement
