Advertisement
Flat tyre
388
Towing eye
?
Jack
A
Ratchet ring spanner
B
Open the tailgate.
X
Lift the luggage compartment floor upwards
X
(
page 359).
Y
Remove the "Minispare" emergency spare
X
wheel (
page 429).
Y
Flat tyre
Preparing the vehicle
Your vehicle may be equipped with:
MOExtended tyres (tyres with run-flat char-
R
acteristics)
Vehicle preparation is not necessary on vehi-
cles with MOExtended tyres.
a TIREFIT kit (
R
an emergency spare wheel (certain countries
R
only)
Information on changing and fitting a wheel
(
page 413).
Y
Stop the vehicle as far away as possible from
X
traffic on solid, non-slippery and level ground.
Switch on the hazard warning lamps.
X
Safeguard the vehicle against rolling away
X
(
page 191).
Y
If possible, bring the front wheels into the
X
straight-ahead position.
Vehicles with the AIRMATIC package:
X
make sure that the normal vehicle level is
selected (
page 222).
Y
Vehicles with the Off-Road Engineering
X
package: make sure that the normal vehicle
level is selected (
Switch off the engine.
X
Vehicles without KEYLESS-GO: remove the
X
key from the ignition lock.
Vehicles with KEYLESS-GO: open the driv-
X
er's door.
The on-board electronics now have status 0.
This is the same as the key having been
removed.
Vehicles with KEYLESS-GO: remove the
X
Start/Stop button from the ignition lock
(
page 158).
Y
Make sure that the passengers are not endan-
X
gered as they do so. Make sure that no one is
page 387)
Y
page 216).
Y
near the danger area while a wheel is being
changed. Anyone who is not directly assisting
in the wheel change should, for example,
stand behind the barrier.
Get out of the vehicle. Pay attention to traffic
X
conditions when doing so.
Close the driver's door.
X
Place the warning triangle at a suitable dis-
X
tance (
page 386). Observe legal require-
Y
ments.
Unload heavy luggage.
X
i
Only operate the tyre inflation compressor
using a 12 V socket, even if the ignition is
turned off (
page 364).
Y
An emergency cut-off ensures that the on-
board voltage does not drop too low. If the on-
board voltage is too low, the power to the
sockets is automatically cut. This ensures
that there is sufficient power to start the
engine.
MOExtended tyres (tyres with run-flat
characteristics)
General notes
With MOExtended tyres (tyres with run-flat char-
acteristics), you can continue to drive your vehi-
cle even if there is a total loss of pressure in one
or more tyres. The affected tyre must not show
any clearly visible damage.
You can recognise MOExtended tyres by the
MOExtended marking which appears on the tyre
wall. You will find this marking next to the tyre
size designation, the load-bearing capacity and
the speed index.
MOExtended tyres may only be used in conjunc-
tion with an activated tyre pressure loss warning
system or tyre pressure monitor.
If a pressure loss warning message appears
in the multifunction display:
observe the instructions in the display mes-
R
sages (
page 330)
Y
check the tyre for damage
R
if driving on, observe the following notes
R
The driving distance possible in run-flat mode is
approximately 80 km when the vehicle is parti-
ally laden and approximately 30 km when the
vehicle is fully laden.
Advertisement
