Advertisement
If the head restraint is fully lowered, it is nec-
X
essary to press release catch :.
To raise: pull the head restraint up to the
X
desired height.
To lower: press release catch : and push
X
the head restraint down until it is in the
desired position.
Adjusting the rear seat head restraint
angle
You can only adjust the two outer head
restraints.
Using both hands, reach back and grasp the
X
sides of the head restraint.
Pull the lower edge of the head restraint for-
X
wards or back until it is in the desired position.
Removing and fitting the rear seat head
restraints
To remove: pull the head restraint up to the
X
stop.
Press release catch : and pull the head
X
restraint out of the guides.
To refit: insert the head restraint so that the
X
notches on the bar are on the left when
viewed in the direction of travel.
Push the head restraint down until you hear it
X
engage in position.
Adjusting the rear seat backrests
You can adjust the angle of the backrests in the
second row of seats. There are several possible
detent positions.
Pull the left or right release lever ; upwards
X
in the direction of the arrow until the relevant
backrest : is fully released.
Pull backrest : forwards in the direction of
X
the arrow and allow it to engage.
To ensure that the backrest has engaged, lean
X
firmly against backrest :.
Adjusting the multicontour seat
The multicontour seat can be adjusted via the
multimedia system (see the separate operating
instructions).
Seats
111
Z
Advertisement
