Advertisement
Warning and indicator lamps in the instrument cluster
Display messages
Â
Remove starting
Remove
starting but‐
but‐
ton, then
ton,
then insert
insert key
key
Warning and indicator lamps in the instrument cluster
General notes
Some systems carry out a self-diagnosis when the ignition is switched on. Several warning and
indicator lamps can thereby temporarily light up or flash. This behaviour is non-critical. These
warning and indicator lamps only indicate a malfunction if they light up or flash after the engine is
started or during a journey.
Safety
Seat belts
Warning/
N N Signal type
indicator
Possible causes/consequences and M M Solutions
lamp
ü
N Only for certain countries: the red seat belt warning lamp lights up for 6 seconds
after the engine starts.
The seat belt warning lamp reminds the driver and front passenger to fasten their
seat belts.
Fasten your seat belt (
X
ü
N Only for certain countries: the red seat belt warning lamp lights up after the
engine starts. In addition, a warning tone sounds for up to 6 seconds.
The driver's seat belt is not fastened.
Fasten your seat belt (
X
The warning tone ceases.
Possible causes/consequences and M M Solutions
Because there is interference from a strong source of radio waves, the
key is not detected whilst the engine is running.
A warning tone also sounds.
Pull over and stop the vehicle safely as soon as possible, paying
X
attention to road and traffic conditions.
Secure the vehicle against rolling away (
X
Insert the key into the ignition lock and bring into key mode.
X
The key detection function has a temporary malfunction or is faulty.
R
The key is continually undetected.
R
A warning tone also sounds.
Insert the key into the ignition lock and turn it to the desired posi-
X
tion.
Consult a qualified specialist workshop.
X
page 47).
Y
page 47).
Y
page 191).
Y
337
Z
Advertisement
