Perform Engine Maintenance - Deutz Models - Genie S-100 Service Manual

January 2010
REV A
a
b
c
d
a turntable
b dial indicator
c drive chassis
d turntable rotation bearing
5 At the dial indicator, adjust it to "zero" the
indicator.
6 Fully extend the boom and lower to a horizontal
position.
7 Note the reading on the dial indicator.
Result: The measurement is less than
0.063 inch / 1.6 mm. The bearing is good.
Result: The measurement is more than
0.063 inch / 1.6 mm. The bearing is worn and
needs to be replaced.
8 Fully retract the boom and raise the boom to full
height. Visually inspect the the dial indicator to
be sure the needle returns to the "zero" position.
9 Remove the dial indicator and rotate the
turntable 90°.
10 Repeat steps 4 through 9 until the rotation
bearing has been checked in at least four
equally spaced areas 90° apart.
11 Lower the boom to the stowed position and turn
the machine off.
12 Remove the dial indicator from the machine.
Part No. 62401
Section 4 • Scheduled Maintenance Procedures
D-9
Perform Engine Maintenance -
Deutz Models
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz F4L913 Operation Manual
(Deutz part number 0297 7341).
Deutz F4L913 Operation Manual
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
S-100 & S-105 & S-120 & S-125
CHECKLIST D PROCEDURES
Engine specifications require that
this procedure be performed every
1000 hours.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
62446
4 - 59