Perform 30 Day Service; Perform Engine Maintenance - Perkins Models - Genie S-100 Service Manual

Section 4 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-11

Perform 30 Day Service

The 30 day maintenance procedure is a one time
sequence of procedures to be performed after the
first 30 days or 40 hours of usage. After this
interval, refer to the maintenance checklists for
continued scheduled maintenance.
1 Perform the following maintenance procedures:
· A-14 Grease the Turntable Rotation
Bearing and Rotate Gear
· B - 9 Check the Lug Nut Torque
(including the tires and wheels)
· B-10 Check the Oil Level in the
Drive Hubs
· D - 4 Check the Turntable Rotation
Bearing Bolts
· D-12 Replace the Hydraulic Filter
Elements
4 - 14
A-12
Perform Engine Maintenance -
Perkins Models
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Perkins 1004 User's Handbook
(Perkins part number TPD 1349E).
Perkins 1004 User's Handbook
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
S-100 & S-105 & S-120 & S-125
January 2010
Engine specifications require that
this procedure be performed every
50 hours or weekly, whichever
come first.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
Part No. 62401
REV A
61376