Perform Engine Maintenance - Perkins Models; Perform Engine Maintenance - Deutz Models - Genie S-100 Service Manual

Section 4 • Scheduled Maintenance Procedures
CHECKLIST E PROCEDURES
E-4
Perform Engine Maintenance -
Perkins Models
Engine specifications require that
this procedure be performed every
2 years.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Perkins 1004 User's Handbook
(Perkins part number TPD 1349E).
Perkins 1004 User's Handbook
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
4 - 66
E-5
Perform Engine Maintenance -
Deutz Models
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Deutz F4L913 Operation Manual
(Deutz part number 0297 7341).
Deutz F4L913 Operation Manual
61376 Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
S-100 & S-105 & S-120 & S-125
January 2010
Engine specifications require that
this procedure be performed every
2 years.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
Part No. 62401
REV C
62446