Check The Exhaust System - Genie S-100 Service Manual

Section 4 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
B-8

Check the Exhaust System

Genie requires that this procedure
be performed every 250 hours or
quarterly, whichever comes first.
Maintaining the exhaust system is essential to
good engine performance and service life. Running
the engine with a damaged or leaking exhaust
system can cause component damage and unsafe
operating conditions.
Bodily injury hazard. Do not
inspect while the engine is running.
Remove the key to secure from
operation.
Bodily injury hazard. Beware of hot
engine components. Contact with
hot engine components may cause
severe burns.
Cummins and Perkins models:
1 Be sure that all fasteners are tight.
2 Inspect all welds for cracks.
3 Inspect for exhaust leaks; i.e., carbon buildup
around seams and joints.
4 - 24
Deutz models:
1 Remove the engine pivot plate retaining
fastener. Swing the engine pivot plate out away
from the machine.
2 Locate the engine pivot plate anchor hole at the
pivot end of the engine pivot plate.
3 Install the bolt that was just removed into the
anchor hole to secure the engine pivot plate
from moving.
4 Be sure that all fasteners are tight.
5 Inspect all welds for cracks.
6 Inspect for exhaust leaks; i.e., carbon buildup
around seams and joints.
7 Remove the engine pivot plate retaining fastener
from the engine pivot plate anchor hole at the
pivot end of the engine pivot plate.
8 Swing the engine pivot plate in towards the
machine.
9 Install the bolt that was just removed into the
original hole to secure the engine pivot plate.
S-100 & S-105 & S-120 & S-125
a
a engine pivot plate anchor hole
b engine pivot plate retaining fastener
Crushing hazard. Failure to install
the bolt into the engine pivot plate
to secure it from moving could
result in death or serious injury.
Crushing hazard. Failure to install
the bolt into the engine pivot plate
to secure it from moving could
result in death or serious injury.
January 2010
REV B
b
Part No. 62401