Foot Switch - Genie S-100 Service Manual

First Edition • First Printing
PLATFORM CONTROLS
1-4

Foot Switch

How to Test the Foot Switch
Perform this procedure with the
key switch in the
1 Disconnect the wire connector from the foot
switch cable at the back of the platform.
2 Remove the foot switch guard mounting
fasteners from the platform.
3 Remove the foot switch mounting fasteners that
attach the foot switch to the foot switch guard.
4 Remove the cover plate from the bottom of the
foot switch to access the foot switch wire
terminals.
5 Do not press down the foot switch. Connect the
leads from an ohmmeter or continuity tester to
the wire combination listed below and check for
continuity.
Test
black to white
(C to N.O.)
Part No. 62401
6 Press down the foot switch. Connect the leads
Test
black to white
position.
OFF
(C to N.O.)
Desired result
no continuity
(infinite )
Genie S-100 • S-105 • S-120 • S-125
Section 7 • Repair Procedures
from an ohmmeter or continuity tester to the
wire combination listed below and check for
continuity.
Desired result
continuity
(zero )
7 - 14