Display Module - Genie S-100 Service Manual

First Edition • First Printing

Display Module

This table lists the various screens and menu options of the operating software. Some display menus are
for informational purpose only, while others can be changed to alter the machine operating parameters.
The key switch must be in the
Screen or Menu
Operator
With key switch
Machine
Status
With the key switch
Unit of
and hold the
Measure
the key switch to the
and
Release the
Language
With the key switch
Drive
and hold the
Functions
the key switch to the
Release the
press
With the key switch
Boom
and hold the
Function
the key switch to the
Speeds
Release the
press
Part No. 62401
position before entering the programming mode.
OFF
Procedure
Default
, press the
ON
at the same time.
and
, press
OFF
button and turn
position.
ON
button and press
.
, press
OFF
button and turn
position.
ON
button and
.
, press
OFF
button and turn
position.
ON
button and
.
Genie S-100 • S-105 • S-120 • S-125
Section 7 • Repair Procedures
Description
H our m et er
Engi ne speed
Engi ne oi l pr essur e PSI
Engi ne oi l pr essur e KPA
Engi ne t em per at ur e ° F
Engi ne t em per at ur e ° C
Tur nt abl e l evel sensor X°
Tur nt abl e l evel sensor Y°
Hydraulic pressure
Boom length
Boom angle
Axle status
Metric/Imperial measurements
Language selection
Drive output max forward
Drive output max reverse
Elevated drive % (>80 ft, >24.4 m)
Elevated drive % (<80 ft, <24.4 m)
Stowed drive %
Drive acceleration %
Drive deceleration %
Speed limit on steer angle
Boom up/down speed % (fully retracted)
Boom up/down speed %
(<80 ft, <24.4 m)
Boom up/down speed %
(>80 ft, >24.4 m)
Boom up/down speed %
(>100 ft, >30.5 m)
Turntable rotate speed %
(<80 ft, <24.4 m)
Turntable rotate speed %
(>80 ft, >24.4 m)
Jib boom up/down ramp deceleration
7 - 2