How To Use The Safety Arm; How To Fold Down The Guardrails - Terex Genie GS-1932 XH Operator's Manual

Eighth Edition • Second Printing

How to Use the Safety Arm

1 Raise the platform approximately 8ft/2.4 m to
13 ft/4.0 m from the ground.
2 Rotate the safety arm away from the machine
and let it hang down.
3 Lower the platform until the safety arm rests
securely on the link. Keep clear of the safety
arm when lowering the platform.

How to Fold Down the Guardrails

GS-1530, GS-1532, GS-1930, GS-1932,
GS-2032, GS-2632 and GS-3232
The platform railing system consists of one fold
down rail section for the extension deck and one
section for the main deck. All sections are held in
place by four wire lock pins.
1 Fully lower the platform and retract the platform
extension.
2 Remove the platform controls.
Fall hazard. Use caution and maintain a firm
footing on the platform floor at all times while
folding the guard rails.
3 From inside the platform, remove the two
extension deck lock pins.
Keep hands free of pinch points.
4 From the middle of the extension deck railing,
fold down the extension deck rail assembly
toward the rear of the unit.
Part No. 1296776GT
5 At the rear of the main deck, remove the two
main deck lock pins.
Keep hands free of pinch points.
6 From the middle of the unit, fold down the main
deck railing assembly toward the front of the
unit.
7 Remove the lock pin from the entry swing tube.
Raise and step through the entry swing tube,
lower the entry swing tube, and insert the lock
pin.
8 Carefully open the gate and exit the platform.
9 Insert the four lock pins back into each side rail
bracket.
Note: To assist in the removal and replacement of
the wire lock pins, pull or push back on the railing to
compress the rubber bumpers.
™ ™
GS -30 • GS -32 • GS
Operating Instructions
™
-46
Operator's Manual
77