Toro Greensmaster Flex 1018 Service Manual page 86

Assembling the Transmission Gear Box Assembly (continued)
Traction and Reel Drive Systems: Service and Repairs
g259956
1. Sleeve bushing
2. Oil seal
7. Insert the sleeve bushing (Item 16 in
(26) until the sleeve bushing is flush with the transmission housing; refer
to Figure 37.
8. Press the oil seal (item 15 in
so that the seal is recessed from 1.27 mm (0.05 in) from the edge of the
transmission housing; refer to
orientated toward the center of the transmission housing.
9. Apply a coat of grease to the O-ring seal (item 18 in
the groove of the traction selector shaft (19).
10. Insert the straight bushings (item 4 in
housing (26). Press the straight bushings into the transmission housing
bore so that the bushings are recessed from the edge of the transmission
housing; refer to Figure
11. Apply a coat of grease to the O-ring (item 18 in
traction selector shaft (item 19 in
(item 19 in Figure 33) into the transmission housing (26).
12. Apply a coat of a grease to the O-ring (item 3 in
groove of the traction selector shaft (19). Slide the spacer bushing (2) onto
the traction selector shaft (19) and secure with a retaining ring (1).
13. Install the groomer pin (item 20 in
(19).
14. Install the detent ball (item 10 in
into the transmission housing assembly (26).
15. Insert the input shaft (item 19 in
assembly (20) and secure with the thin lock nut (18). Torque tighten the thin
lock nut to 47.5 to 61 N∙m (35 to 45 ft-lbs).
16. Use a press to install the 2 new ball bearings (item 6 in
spur gear (17) and secure with the 2 retaining rings (5).
17. Apply a coat of grease to the O-ring (item 2 in
O-ring onto the short bearing pin (1). Install the spur gear assembly (17) and
Figure 37
3. Press flush
Figure
Figure 33) into the transmission housing (26)
Figure 37. Ensure that the oil seal lip is
Figure
36.
Figure 33). Insert the traction selector shaft
Figure 33) onto the traction selector shaft
Figure 33), detent spring (9) and plug (8)
Figure 35) into the transmission housing
Page 5–32
33) into the transmission housing
Figure 33) and slide onto
33) into the transmission
Figure 33) and slide onto the
Figure 33) and slide onto the
Figure 35) into the
Figure 35) and slide the
Greensmaster ® Flex 1018/1021
20247SL Rev A