Toro Greensmaster Flex 1018 Service Manual page 109

Installing the Throttle Cable
Greensmaster ® Flex 1018/1021
20247SL Rev A
1. Connect the throttle cable end to the throttle arm (9).
2. Slide the throttle cable (3) into the upper receiver weldment (1) and tighten
the lock nut (2).
3. Install the throttle arm to the handle assembly.
4. Route the throttle cable (3) to the engine. Ensure that the throttle cable is
routed on the left side of the engine.
5. Install the throttle cable (item 2 in
(1) as follows:
A. Slide and secure the throttle cable end into the governor lever (1).
B. Place the throttle cable under the cable clamp (3).
C. Ensure that the throttle cable is in the SLOW position and with engine
running slide the cable through the cable clamp to achieve 1850 to 1950
rpm.
D. Tighten the screw on the cable clamp to secure the throttle cable.
6. Check the throttle cable adjustment; refer to Operator's Manual.
7. Install the lower cover and control cover to the handle assembly.
Figure 49) to the engine governor linkages
Page 7–5 Controls, Wheels and Accessories : Service and Repairs