Toro Greensmaster Flex 1018 Service Manual page 117

Installing the Reel Cable
Greensmaster ® Flex 1018/1021
20247SL Rev A
1. Secure the reel cable (item 1 in
follows:
A. Install the cable spring (3) to the clevis connector (10) on the reel lever
assembly (7). Orientate the cable spring hook end toward front of the
machine.
B. Slide the cable (1) into the upper receiver weldment (12). Ensure that the
jam nut (2), flat washer and lock washer are on both sides of the bracket.
Adjust jam nuts so that equal amount of cable threads are visible above
the jam nuts. Leave the jam nuts snug until final cable adjustment.
2. Route the reel cable to the reel selector assembly (item 2 in
install the reel cable (4) as follows:
A. Slide the cable eyelet to the reel selector assembly (2) and secure with
a retaining ring (1).
B. Position the reel cable (4) to the casting slot of the engine base with a
jam nut (3), flat washer and a lock washer on each side of the slot.
3. Make final adjustment of the reel cable at the reel cable lever assembly.
Adjust the cable jam nuts to remove the slack in the clutch cable.
4. Check the reel cable adjustment; refer to Operator's Manual.
5. Install the lower cover and control cover to the handle assembly.
6. Attach the spark plug wire to the engine spark plug.
Figure 54) to the traction lever assembly as
Page 7–13 Controls, Wheels and Accessories : Service and Repairs
Figure 55) and