Toro Greensmaster Flex 1018 Service Manual page 141

Removing the Bedbar
Greensmaster ® Flex 1018/1021
20247SL Rev A
Note: Refer to Figure 70
1. Remove the cutting unit from the machine and place the cutting unit on a flat
work surface; refer to Operator's Manual.
2. Loosen the nuts (11) on the end of each bedbar adjuster assembly (1) until
the washers (9) are loose.
3. Tip the cutting unit to expose the bedknife and support the rear of the cutting
unit; refer to Supporting the Cutting Unit when Servicing (page
g313909
1. Side plate
2. Rubber bushing
3. Nylon bushing
4. Plastic washer (2 each)
5. Metal washer
4. Loosen the locknuts (item 8 in
5. Remove the two bedbar bolts (item 7 in
four plastic washers (4) from the cutting unit side plates (1).
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when handling the bedbar.
6. Remove the bedbar assembly (8) from the cutting unit.
7. Inspect the nylon bushings (item 3 in
the side plates for wear or damage. Replace the bushings if necessary.
during this procedure.
Figure 71
6. Bedbar
7. Bedbar pivot bolt
8. Lock nut
9. Bed knife
10. Screw (13 each)
Figure 71) on each bedbar bolt (7).
Figure
CAUTION
Figure
Page 8–5
8–2).
71), two flat washers (5) and
71) and rubber bushings (4) in
DPA Cutting Units: Service and Repairs