Toro Greensmaster Flex 1018 Service Manual page 143

Installing the Bedbar (continued)
Greensmaster ® Flex 1018/1021
20247SL Rev A
7. Install the bedbar bolt assemblies (item 7 in
washers are not caught on the threads of the pivot bolts. Torque tighten each
bedbar bolt (7) from 22 to 27 N∙m (190 to 240 in-lb).
Do not over tighten the lock nuts as this can distort the side plates
and affect reel bearing alignment. When the lock nut is correctly
tightened, the inside washers may be loose.
8. Tighten both lock nuts (item 8 in
not have any end play and can still can be rotated.
9. Tighten the nut (item 11 in
until the adjuster spring (10) is fully compressed, then loosen the nut (11) to
1/2 turn.
10. Adjust the bedknife to reel contact; refer to the Cutting Unit Operator's
Manual.
IMPORTANT
Figure 72) until outside metal washers do
Figure 70) on each bedbar adjuster screw (7)
Page 8–7
Figure 72). Make sure that the
DPA Cutting Units: Service and Repairs